Landoll Brillion M881, Руководство оператора

Страница: 45 / 52

MAINTENANCE
2K795 4-5
Clamp Tightening Procedure
The tightening procedure and torque requirement is
critical in keeping in keeping the clamp tight and also has
a significant affect on the bearing life of the axles with
internal bearings.
Clamp Tightening Procedure:
Check axle and clamp for burrs on mating surfaces.
Remove end play between wheels by sliding wheels
toward the fixed end of the axle.
Position clamp snugly against the end wheel.
Tighten the U-bolt evenly to 57 Ft/Lbs (U-bolt must be
tightened first.)
See Figure 4-3.
Tighten set screws to 37 Ft/Lbs (Some clamps do not
have set screws.)
If the axle has an internal bearing, check that it turns
freely. You should be able to turn the bearing with your
fingers. If rotation is jerky, loosen set screws and U-bolt
until bearing turns smoothly. It may be necessary to
loosen and reposition clamp.
The torque requirement is recommended for axles
without internal bearings, but is not critical.
Axle Installation :
When installing a roller axle with an internal bearing onto
a support bracket, it is important to keep the roller axle
aligned as straight as possible to the installed position. If
the roller assembly is significantly out of line when sliding
it unto a fixed support, the inner race of the bearing may
crack and cause premature bearing failure.
Figure 4-3: Clamp Tightening
0DLQW5ROOHU%UJ&ODPS(QG
7LJKWHQWRIWOEV
7LJKWHQWRIWOEV