Landoll Brillion CPPR2-5, Руководство оператора и каталог запасных частей

Страница: 16 / 48

2-6 9D990-2401
ASSEMBLY
TABLE OF CONTENTS INDEX
Spring Clamp Shank Assembly
Remove the 3/4-10 U-Bolts, Lock Washers and Nuts.
Place Shank Assembly Clamp under the frame and
re-insert the U-Bolts over the top of the frame and through
the Shank Assembly Clamp. Secure with Lock Washer
and Nut.
See Figure 2-5.
Figure 2-5: Spring Clamp Shank Assembly
Check the tension on the Shank Spring. For normal
operation the Lock Nuts on the Spring mounting should be
tightened so that one inch of thread is exposed.
See
Figure 2-6.
Figure 2-6: Spring Tension
Rigid Clamp Shank Assembly
Remove the front 3/4-10 x 7-1/2 Bolt, Lock Washer and
Nut and loosen the 5/8-11 Nuts so that they are flush with
the end of the Bolt. Slide the Shank Assembly onto the
Frame Tube until the Shank Support seats on the bottom
of the Frame Tube. Re-insert the 3/4-10 x 7-1/2 Bolt, Lock
Washer and Nut and tighten the 5/8-11 Nuts.
See
Figure 2-7.
Figure 2-7: Rigid Clamp Shank Assembly
U-Bolt,3/4-10
Lock Washer,3/4
Nut,Hex 3/4-10
1"
Exposed Thread
Locknut
CPP OpShankAsm
Rigid Shank Mount
Plate
Plate
Bolt,5/8-11 x 8
Bolt,3/4-10 x 7-1/2
Lock
Washer,3/4
Nut,Hex 3/4-10
Hex Nut,5/8-11
Lock Washer,5/8