Landoll Bendi B40i4, Руководство оператора

Страница: 45 / 66

OPERATING THE B40I4 FORKLIFT
4-7
Dash Display
The Dash Display is centered in front of the steering
wheel. See Figure 4-8. It displays Engine Coolant
Temperature, Fuel, Hour Meter (accurately displaying
active operating hours), Clock, Warning Icons and overall
truck operational mode and status.
Figure 4-8: Dash Panel Display
Figure 4-9: Fork Positioner
Fork Positioner, Non-Side Shifting
Fork positioner options are hydraulically driven units that
allow the forks to move equal distance from each other to
accommodate the size of the load being moved (See
Figure 4-9).
The forks start at the center of the carriage and move
equal distance to the outside and back again as indicated
by letters C and D (See Figure 4-9). A push button is
added to the side shift control lever.
Precautions for LP Gas Engines

CAUTION
Liquefied Petroleum Gas (LPG)
A fuel gauge is embedded, as an icon, in the LCD dash
display. The gauge indicates the amount of fuel in the
tank. The fuel icon flashes when there is less than 10%
remaining in the tank.
LPG Tank Removal
Use the following procedure to remove the LPG tank:
1. Removable LPG tanks can be replaced indoors only
if the lift truck is a minimum of 25 feet (8 meters) from
any open flame or ignition source.
2. Move the lift truck to the area where LPG tanks are
changed.
3. Turn the tank shut-off valve clockwise until the fuel
valve is completely closed.
4. Run the engine until it stops, then turn the Keyswitch
to the OFF position.
5. Disconnect the quick disconnect fitting.
6. Release the tank latch & remove from the bracket.
• Do not run at low idle for prolonged periods.
• Never operate engine faster than governed
speed. Excessive speeds are harmful. The
governor is set at the factory and needs no
adjustment.
• Immediately after the engine starts, ensure
the low oil pressure icon has gone out. If it is
not, stop the engine and inspect the oil
system to find the cause of failure. If you are
unable to find the cause, be sure to consult
your service personnel before operating the
engine. Under no circumstances attempt
operation without oil pressure.
• Make sure all gauges are in the normal
operating zone before operating the truck.
• Frequently read the dash display indicators.