Landoll Bendi B40i4, Руководство оператора

Страница: 14 / 66

1-6 F-808-R0
FORKLIFT SAFETY AND FAMILIARITY
NOTICE
Lock Out/Tag Out
IMPORTANT
When performing maintenance or repair on the Bendi
B40i4 truck, unless the truck must be running for
testing, remove the key from the key switch. In
addition, because it’s possible to have a duplicate
key, install a commercially available Lock Out/Tag
Out device on the truck. Also, install a lockout
warning reminder on the steering wheel warning that
the truck is not available for use.
Operator Safety Training

DANGER
Before you start using the B40i4 forklift you must become
familiar with its capabilities. Thoroughly read and
understand the material contained in this Operator’s
Manual and the various machine signs (decals) found on
your vehicle. Whether you are a new operator or have
used forklifts for many years, read through this Operator’s
Manual. It provides step-by-step instructions to help you
operate the Bendi B40i4 forklift in a safe and efficient
manner.
Seat Belt
The drivers seat belt must always be worn when driving
the forklift. Sit up straight in the driver’s seat. The lap
restraint must be worn low and snug on the hips, just
touching the thighs and must not be twisted.

WARNING
IMPORTANT
Make sure the release button on the buckle is
positioned so you can unbuckle the seat belt quickly
in case of an emergency.
Seat Safety Switch
A seat switch tells the vehicle controllers when a driver is
in the operator’s seat. Traction operations will shut down
if the seat switch opens, signaling that a driver is not in
the operator’s seat.
NOTE
A two to three second delay is programmed into the seat
switch to avoid nuisance shutdown and interruption of
normal operations.
Parking Brake
The parking brake is located on the left stop pedal, from
the operator’s seat, and is engaged into place with your
foot using the levers on the side of the pedal. Pushing to
the bottom and left will set the park brake, and more force
put in the upper left to disengage it. It includes a safety
interlock that shuts down the drives, disables the
direction control lever and applies the brakes to prevent
further truck movement. To continue, you must set the
direction lever to NEUTRAL, release the parking brake,
and then set the lever to the desired direction. See
Figure 1-3.
Figure 1-3: Park Brake Mechanism
In the interest of operator safety and in
compliance with OSHA regulations, guidelines
have been developed for performing service and
maintenance on the truck.
Before performing service and maintenance on
the truck, review the following sections in this
manual for additional procedures to be followed.
Every forklift operator must be trained in
accordance to the rules provided by appropriate
legislation. Your employer is to ensure that each
powered industrial truck operator is competent to
operate a powered industrial forklift safely, as
demonstrated by the successful completion of
the relevant training course. Operating a powered
industrial truck without the proper training can
cause serious injury or death.
A twisted belt has the potential to cause serious
injury. In a crash or a tip-over, the full width of the
belt would not be available to take up the impact
forces.