Landoll 3631-30, Руководство оператора

Страница: 26 / 144

2-8 F-982-0223
ASSEMBLY
TABLE OF CONTENTS
Rockshaft Cylinder and
Transport Lock Installation
1. Attach 4-1/2 x 14 hydraulic cylinder rod end to
Rockshaft Arm with provided pin. See Figure 2-9.
2. Align base end of cylinder between the frame lug.
Attach the Transport Lock to the base end of the
cylinder, by sliding the 3 Hole Pin through the top hole
of the Transport Lock and through the Frame Lugs
and Rockshaft Cylinder Base End. Note location of
2-1/2 x 1-1/4 x 3/4 Washers. Place 1-1/4 x 1-7/8 x
14ga Washer on each side. Secure with 3/8 x 2-1/4
Roll Pins. A Roll Pin must pass through a frame
bushing hole.
3. Attach the Transport Lock Link to the Transport Lock
by placing the Link on the outside of the Transport
Lock and sliding 1 x 2-1/2 Clevis Pin through both
pieces. Place 1 x 1-1/2 x 14ga Washer on the outside
by the clevis pin hole. Secure with 3/16 x 2 Cotter Pin.
Check to ensure there is no binding.
4. Attach the Transport Lock Bracket to the top of the
Rear Frame tube, aligning it with the 4-1/2 x 14
Hydraulic Cylinder, place the Clamp under the tube
and insert two 5/8-11 x 4-1/2 Bolts through the top of
the Transport Lock Bracket and through the Clamp.
Secure with Locknuts.
5. Attach the Transport Lock Lever to the Transport Lock
Bracket by placing it into the top of the bracket, then
sliding the 5/8-11 x 4-1/2 Bolt, Flat Washer, and 1-1/8
long Bushing through the holes and through the
Bushing and Flat Washer on the other side. Secure
with Locknut.
6. Attach the Transport Lock Link to the Transport Lock
Lever by sliding the 3/4-10 x 2 Bolt, Flat Washer,
11/16 long Bushing through both pieces and securing
with Flat Washer and Locknut.
7. Position Transport Lock Lever to field position.
(Unlocked Position) See Figure 3-5.