Landoll 336C, Руководство оператора

Страница: 29 / 70

3-16.3 Connect winch #5 (See Figure 3-6) to
the next vehicle and pull it to the front of the
lower deck as far as possible without interfer-
ing with the upper deck. Secure with chains
(See Section 3-17).
3-16.4 Free-wheel the winch cable from winch
#7 (See Figure 3-6) out until it is at the rear
of the lower deck so it is accessible after
loading the next vehicle.
3-16.5 Connect winch #6 (See Figure 3-6) to
the next vehicle and pull it to the center posi-
tion on the lower deck. Secure with chains
(See Section 3-17) .
3-16.6 Connect winch #7 (See Figure 3-6) to
the next vehicle and pull it to the rear posi-
tion on the lower deck. Secure with chains
(See Section 3-17) .
3-16.7 Lower the front of the semitrailer. Then
move the axles to the rear until the semi-
trailer is in transport position.
3-16.8 Lower the arms; front first, then middle,
then rear; to allow a minimum clearance of
1" above the vehicles on the lower deck
(See Figure 3-11) .
3-17 SECURING THE LOAD
3-17.1 All vehicles must be securely tied front
and rear to the deck with 5/16 HI-TEST
chain. Key holes are provided in the front
and rear of each deck floor to anchor and
D-rings are provided in the mid section of
each trailer deck for anchoring (See Figure
3-12) .
3-17.2 The front of each vehicle must be se-
cured to the load anchor ahead of the vehi-
cle, and the rear of each vehicle must be se-
cured to the anchor behind it.
3-17.3 There must not be any slack in the
chains or the vehicles will be allowed to shift.
A shifting load will create sufficient momen-
tum to break HI-TEST chains. Remove chain
slack by using chain boomers, or other slack
adjusters designed to be used for securing
loads.
3-17
Figure 3-12 Securing the Load