Landoll 330B, Руководство оператора

Страница: 51 / 64

4-11.3 Mounting Tire and Wheel
a. Make sure that all mounting surfaces are
clean and free of rust, dirt or paint. A wire
brush may be used to clean these surfaces
(See Figure 4-17) .
b. Position the inner disc wheel over the studs,
being careful not to damage the stud threads.
Make sure that the disc wheel is flat against
the mounting surface and that there is clear-
ance between the disc wheel taper and brake
drum.
c.
Install the inner capnuts on the studs and
tighten to fifty foot-pounds using the se-
quence illustrated in Figure 4-18 . Make cer-
tain that the left-handed threads are installed
on the driver side of the vehicle and the right-
handed threads are installed on the curbside
of the vehicle.
d. Tighten the inner capnuts to full torque of
450 to 500 foot-pounds using the sequence
shown in Figure 4-18.
e. Position the outer disc wheel over the
capnuts being careful not to damage the inner
capnut threads. Be sure the valve stems for
both the inner and outer tire are accessible.
4-23
Figure 4-17 Mounting Tires and Wheels