Landoll 330A, Руководство оператора

Страница: 15 / 62

3-3 CONNECTING TRACTOR SERVICES TO THE SEMITRAILER
3-3.1 Connect the tractor 7-way electrical plug
to the electrical receptacle on the front of the
semitrailer (See Figure 3-1) .
IMPORTANT
THE KEY ON THE PLUG AND THE KEYWAY IN
THE SOCKET MUST BE PROPERLY ALIGNED
BEFORE INSERTING THE PLUG INTO THE
SEMITRAILER SOCKET.
3-3.2 If you have not already done so, con-
nect the tractor hydraulic lines to the semi-
trailer, unless your semitrailer is equipped
with the auxiliary hydraulic power engine
package.
IMPORTANT
SOME OIL MAY NEED TO BE REMOVED FROM
THE TRACTOR RESERVOIR TO ALLOW ROOM
FOR 12 GALLONS OF ADDITIONAL OIL DIS-
PLACED FROM THE SEMITRAILER HYDRAULIC
SYSTEM.
3-4 TRACTOR AND SEMITRAILER CHECK-OUT
3-4.1 While hydraulic power is operating,
raise the front end of the semitrailer with the
TRAILER TILT lever (See Figure 3-2) until
weight is off the landing gear. Raise landing
gear. Secure each leg with a park stand re-
taining pin in fully retracted position before
transporting.
WARNING
LANDING GEAR LEGS MUST BE
FULLY RETRACTED AND SECURED
WITH PINS BEFORE OPERATING OR
MOVING SEMITRAILER.
3-4.2 Lower the front end with the TRAILER
TILT lever until the semitrailer is fully low-
ered. Hold lever in the down position until
hydraulic system works against the bottomed
out hydraulic tilt cylinders.
3-4.3 Verify that the traveling undercarriage is
completely slid back to transport position.
Shut off hydraulic power.
3-3
Figure 3-1 Service Hookups (Front View)
Figure 3-2 Hydraulic Control Levers