Landoll 2512 Series, Руководство оператора

Страница: 20 / 42

3-2 F-1040-0320
ASSEMBLY INSTRUCTIONS
TABLE OF CONTENTS
Assembly Preparation
1. Hook up the In-Row Ripper to a tractor using the
three-point hitch.
2. Raise the unit about 36” and place stands under the
main frame to prevent accidental lowering.

WARNING
Jackstand Installation
1. Remove jackstand(s) from frame.
2. Remove rigid gauge adjustment pin and 3/16 hair pin
from outer jackstand tube.
3. Insert jackstand through bottom of outer jackstand
tube and pin at desired level with rigid gauge
adjustment pin and 3/16 hair pin
( See Figure 3-1 .)
SMV Bracket Installation
1. Attach the SMV mounting bracket at a point where
emblem is visible from rear of machine, using u-bolt
and 5/8-11 flange head serrated nuts
( See
Figure 3-1 .)
2. Attach SMV emblem to top of SMV mounting bracket
using 1/4-20 x 1 hex head cap screws, flat washers,
and hex lock nuts
( See Figure 3-8 .)
Figure 3-1: 2512 Series Parts Identification
Do not attempt to lift heavy parts (such as the
frame), manually. Use a hoist or a forklift to move
these parts into position.
SMV EMBLEM
SMV BRACKET
HYDRAULIC
ACCUMULATOR
JACK STAND
COULTER BLADES
ID PLATE
HYDRAULIC RESET CYLINDER