1
CAUTION
Unfold, lower the unit to the ground.
Kit 213907 is for the 3630-25 Model.
Kit 213908 is for the 3630-30NC Model.
Installation
To ensure alignment of assemblies, leave the nuts
loose until completion of final assembly. Use washers as
specified.
After completion of final assembly, tighten all nuts
evenly to prevent misalignment, distortion or binding.
Tighten all screws and nuts to the recommended torques
.
Refer to the operator’s manual for general torque
specifications.
Rotate Harrow 3 x 3 Tube
1.
The 3 x 3 Tube inside the Harrow Assembly is
shipped with the tube horizontal. Remove the
Carriage Bolts that bolts the brackets to the Harrow
plates and rotate the 3 x 3 Tube as shown below.
Re-insert Carriage Bolts and secure.
Figure 1-1: Rotate Harrow 3 x 3 Tube
Do not work on or under this machine unless
securely
blocked and supported by a hoist or
tractor or by other sufficient means.
Tube 3 x 3
Remove Carriage Bolts
Rotate 3 x 3 Tube as shown
Re-Insert Carriage Bolts
3630 CoilHarrowSide
