Landoll 1550 Series, Руководство оператора

Страница: 15 / 36

ASSEMBLY INSTRUCTIONS
3-3
Assembly Preparation
1. Hook up the In-Row Ripper to a tractor using the
three-point hitch. Raise the unit about 36” and place
stands under the main frame to prevent accidental
lowering.

WARNING
Jackstand Installation
1. Remove jackstand(s) from frame.
2. Remove rigid gauge adjustment pin and 3/16 hair pin
from outer jackstand tube.
3. Insert jackstand through bottom of outer jackstand
tube and pin at desired level with rigid gauge
adjustment pin and 3/16 hair pin
(See Figure 3-1.)
SMV Bracket Installation
1. Install the SMV mounting bracket and light bar close
to the center of machine on rear frame member using
1/2-13 X 5-1/2 hex head cap screws and hex lock
nuts
(See Figure 3-1.)
2. Attach plastic SMV emblem to mounting bracket
using 1/4-20 X 1 hex head cap screw and hex lock
nuts.
Tire and Wheel Assembly
1. All hubs and spindles come already assembled from
the factory. Mount the tire and wheel assembly onto
the hubs.
Do not attempt to lift heavy parts (such as the
frame), manually. Use a hoist or a forklift to move
these parts into position.