FIREWOOD CADDY
ASSEMBLY INSTRUCTIONS
For easiest assembly, follow the
assembly steps in this order.
An adjustable wrench or socket wrench
with 10MM socket is needed for assembly.
Assembly time: 10 minutes
1
STEP
Assemble axle rail [ CC1 ] to bottom rail [ BB1 ]
using (2) 35MM bolts [ M ], (2) washers [ N ] and (2)
hexnuts [ P ] as shown in DIAGRAM 1.
Repeat step for axle rail [ CC2 ] and bottom rail
[ BB2 ].
2
STEP
Insert axle [ E ] through holes in bottom rails. Slide
axle until it comes to the stops. See DIAGRAM 2
and 2B. Slide on the (2) spacers [ I ] as shown.
3
STEP
Slide tire and wheel [ F ] onto the axle [ E ] and
spacers [ I ]. Lock tire and wheel to axle using (1)
cotter pin [ J ] per side. Bend cotter pin ends to
lock. See DIAGRAM 2 and 2B.
4
STEP
Insert front rail [ DD ] into the bottom rails and
attach using (2) 35MM bolts [ M ], (2) washers [ N ]
and (2) hexnuts [ P ]. See DIAGRAM 3.
5
STEP
Insert handle rail [ AA ] into the axle rails and
attach using (2) 35MM bolts [ M ], (2) washers [ N ]
and (2) hexnuts [ P ]. See DIAGRAM 3.
6
STEP
Make sure all bolts are tightened securely.
7
STEP
Note the tires are only partially inflated for
shipping purposes. Carefully inflate tires to 30 psi
before use.
DO NOT OVER INFLATE THE TIRES!
SLOWLY AND CAREFULLY INFLATE THE
TIRES TO 30 PSI. MAXIMUM TIRE
PRESSURE IS 30 PSI, DO NOT EXCEED!
WARNING!
30 PSI
MAXIMUM TIRE PRESSURE
!
DO NOT RETURN PRODUCT TO THE
STORE. IF YOU HAVE QUESTIONS OR
HAVE TROUBLE WITH ASSEMBLY,
PLEASE CALL 1-800-321-3473 FOR
ASSISTANCE.
!
1
DIAGRAM
CC2
BB2
CC1
BB1
NOTE: HOLD LOCKING
BOLT IN THE SQUARE
HOLE WHILE TIGHTENING
THE LOCKING HEXNUT.
M
N
P
3
DIAGRAM
AA
DD
M
N
P
M
N
P
2A
DIAGRAM
F
F
I
E
I
2
DIAGRAM
PAGE 2
2B
DIAGRAM
J
8
STEP
Use cover to keep firewood out of the weather.