ASSEMBLY
H
A
NDY HIN
T
S
All sharp edges have been carefully removed during manufacturing process, but please
be careful when handling all components to avoid accident to happen.
Tools required: Either a Philips crosshead or flat bladed screwdriver
and either an adjustable spanner or a pair of pliers.
WARNING
STEP 1 - LID ASSEMBLY & HANGING HOOK
Place round bakelite handle (A) with bolt (P) on lid (E) and
align round bakelite handle with hanging hook (C) which
you place inside of the lid. Then secure with washer (V)
and nut (X).
STEP 2 - ATTACHING HANDLES
Take one of the square handles (B) and remove the two
bolts (Y) and washers (W) that are attached to it. Fix the
handle to the outside of the fire bowl (D), using two
o
f the
holes near the rim. Then fix the second square handle to
the opposite side of the fire bowl.
STEP 3 - FITTING LEGS
Next, take one of the short legs (H) and remove the bolt
(Q) and washer (W) from its top. Place a leg cup (J) over
the top of the leg. Note, that the hole in the cup must go
onto the leg first, so the cup points upwards. Push the bolt
and washer through any one of the four holes in the
bottom of the fire bowl. Next, screw into the top of the
leg, making sure the leg cup sits squarely against the
bottom of the fire bowl. At this point, do not fully tighten
the bolt, but leave some movement in the leg. Now, attach
the other three legs in the same way.
Note: The second short leg must sit next to
the first short leg. This means one of
the handles you fixed to the bowl will
be between the two short legs. This
also applies to the long legs.
(A)
(E)
(C)
(V)
(X)
(P)
(W)
(B)
(Y)
(W)
(D)
(Q)
(W)
(J)
(H)
5