1 800 - LANDICE | [email protected] | WWW.LANDICE.COM
LANDICE, INC.
111 CANFIELD AVE., SUITE A-1
RANDOLPH, NJ 07869
PHONE: (973) 927-9010
FAX: (973) 927-0630
[email protected]
MSI Elevation Motor Calibration Process
NOTE - It is helpful to have two people to calibrate the pot!
For new Landice units, the elevation pot key will be located in the motor pan, as shown above. If
replacing an elevation motor on an older unit, the key will be bound along the grounding wire.
NOTE:
Needle nose pliers can be used in the event the pot key is lost.
Remove the POT sticker to
expose the elevation pot and proceed to the next step.
PLEASE NOTE - ELEVATION POT IS PRESET TO 0.0 IN FACTORY. ONLY
ADJUST THE POT IF NEEDED!
Enter into Diagnostic mode using the specific button combinations for your model treadmill. Ensure
you have elevation motor movement by pressing
Incline Up
for 5 seconds. Next, press
Incline Down
until the elevation motor is at the lowest limit and stops moving. Using the elevation pot key, adjust UP
(clockwise) or DOWN (counter-clockwise) until you have reached the desired pot setting. Power down
the unit, and restart as normal.
PLEASE CALL LANDICE TECHNICAL SERVICE
1-800-526-3423, OPTION 3 FOR FURTHER ASSISTANCE
Revision 09-2019