Landice L Series, Диагностическое и сервисное руководство

Страница: 106 / 127

106
Check speed sensor alignment.
It should be within 1/16" of the flywheel
and parallel to the flywheel.
Is it out of position?
Unplug 3 wire speed sensor connector
from relay board. Check for pushed pins
or Loose wires.
Any found?
Unplug 9 wire upper harness connector
from relay board. Check for pushed pins
or loose wires. Specifically look at 5
(Brown) and 9 (Green).
Any found?
Is speed control wiring OK?
Purple wire from V+ on pwm board to P3 on relay board.
Orange wire from P1 on pwm board to P1 on relay board.
Brown wire from P2 on pwm board to P2 on relay board.
P3 on pwm board has no connection.
Adjust speed sensor:
1. Use 1/2" wrench and loosen
the two lock nuts securing
sensor to it's bracket.
2. Adjust sensor gap to 1/16".
3. Tighten lock nuts.
Repair or replace
speed sensor /
harness assembly.
Repair or replace
upper harness
Correct speed
control wiring.
Replace the speed sensor.
Upper display lights up; treadbelt moves; speed will not increase; L5 error.
5.1
5.2
5.3
5.4
NO
NO
NO
NO
YES
YES
YES
YES