96-61836 • LANDA MVC • REV. 11/04
OPERA
T
O
R’S MANU
AL
PRESSURE W
ASHER
8
OPERATION INSTRUCTIONS
STEP 1: Turn on water at faucet and
pull trigger on spray gun allowing
water to flow until all air has dis-
charged from system. Check for
water leaks; tighten as needed.
STEP 2: Pull wand coupler collar
back and insert desired pressure
nozzle into coupler then secure by
pushing coupler collar forward.
NOTE: Variable pressure control
wand handle must be turned clock-
wise to enable water to flow out of
the high pressure nozzle.
STEP 3: Read engine manual, turn
on gas valve and choke. Turn the
engine switch to the START position
and hold it there until the engine
starts. NOTE: Do not use the elec-
tric starter for more than five sec-
onds at a time. If the engine fails to
start, release the switch and wait ten
seconds before operating the starter
again. When the engine starts, al-
low the engine switch to return to the
ON position. If the engine is to be
started without the battery, turn
switch to start position and pull rope
to start. Turn off choke.
STEP 4: With spray nozzle pointed
away from you or anyone else, press
trigger on spray gun to obtain pres-
surized cold water spray.
Selection of high or low pressure is accompanied by turning the handle.
Note: High pressure nozzle must be inserted at end of wand to obtain high
pressure. To apply soap read operator's manual.
Variable Pressure
Control Handle
Trigger
Variable Pressure
Wand (VP)
High
Pressure
Nozzle
Brass Soap
Nozzle
STEP 5: For hot water, turn the
burner switch ON when a steady
stream of water flows out of the
spray gun. Burner will light automati-
cally.
NOTE: Do not start machine with
burner switch on.
Burner
Switch
Collar
To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com
