Landa EHW Series, Руководство оператора

Страница: 14 / 44

14
Operations
Shutdown Procedures
STEP 1: Rinse all lines (and
injector) with clean water, to
remove any soap residue then turn
toggle switch off.
STEP 2: Turn off water supply. STEP 3: Open spray gun to relieve
remaining pressure and remove
water supply hose.
In freezing conditions, disconnect
water supply and open spray gun to
allow water to drain, then turn off
motor.
CAUTION: Do not allow pump to
run longer than 5 minutes
without water. Disconnect all
hoses to allow water to drain.
CAUTION: With machine off,
open spray gun to release
pressure before removing
discharge hose.
Landa EHW Operator’s Manual 8.941-114.0 - M
CA
UTION
Ne
ver Us
e:
• Bleach, c
hlor
ine products
and o
ther
corrosiv
e chemi
cals
• Liquids conta
ining solv
ents (i.e
. paint thinne
r,gasol
ine ,oil)
• T
ri-sodium phosp
hate products
• Ammonia pro
ducts
• Acid-based products
These chemical
s will har
m the unit and
will da
mage
the
surf
ace being clea
ned.
Use manuf
acturer's detergen
ts as recom
mended in ma
nual
Toggle
Switch
Storage
Pump Storage
CAUTION: Always store your
pressure washer in a location where
the temperature will not fall below
32° F (0° C). The pump in this
machine is susceptible to
permanent damage if frozen.
FREEZE DAMAGE IS NOT COVERED BY
WARRANTY.
If you must store your pressure washer in a location
where the temperature is below 32° F, you can
minimize the chance of damage to your machine by
draining your machine as follows:
1. Stop the pressure washer and detach supply hose
and high pressure hose. Squeeze the trigger of the
spray gun to drain all water from the wand and
hose.
2. Restart pressure washer and let it run briefly (about
5 seconds) until water no longer discharges from
the high pressure outlet.
CAUTION