Land Pride STH2024, Руководство оператора

Страница: 16 / 32

Section 1: Assembly and Set-up
Table of Contents
12/10/18 STH2024 Spike Tooth Harrow 322-315M
12
Electrical Hook-up
Figure 1-5
Detail A
70482
33109
Tractor 7-Pin Electrical Outlet
Figure 1-6
Hook-up LED Lights
Refer to Figure 1-5:
The lead wiring harness (#4) is equipped with a 7-way
round pin connector for connecting to the tractor’s 7-pin
electrical outlet shown in Figure 1-6.
1. Route lead wire harness (#4) through spring hose
loops (#18 & #21).
2. Connect lead wire harness (#4) to the tractor’s
7-way round pin receiver.
37624
IMPORTANT: See Detail A: Connectors on wire
harness (#1 & #2) are labeled “Light” on one end
and “Enhancer” on the other end. Ends labeled
“Light” connect to the LED lights. Ends labeled
“Enhancer” connect to the enhance module (#3).
3. It is best to have a second person verify the lights are
operating. Start tractor and operate lights as follows:
a. Turn on head lights to verify red lights illuminate.
b. Turn on flasher lights to verify amber light are
blinking on and off.
4. If lights did not operate properly, recheck hook-up of
wire harness (#1, #2, & #4) to enhance module (#3).
•
Make sure connector (#1D) with a red wire is
connected to the right-hand wire harness (#1).
•
Make sure connector (#2D) with a yellow wire is
connected to the left-hand wire harness (#2).
•
Make sure connector (#3B) on the lead wire
harness (#4) is connected to connector (#3A) on
enhancer module (#3).
5. Check wire harness routing to make sure wires will
not be pinched as the wings are folded and unfolded
and while raising and lowering the unit.
6. Check hydraulic hose routing to make sure hoses will
not be pinched as the wings are folded and unfolded
and while raising and lowering the unit.
7. Make final adjustments to harnesses (#1, #2, & #4)
and hydraulic hoses (#10 & #11). Add cable ties (not
shown) as needed. When completed, draw all cable
ties up tight.
IMPORTANT: See Detail A: Connector (#1C) has a
Red wire and connects to wire harness (#1) on the
right side. Connector (#2C) has a yellow wire and
connects to wire harness (#2) on the left side.