Land Pride SSP2510, Руководство оператора

Страница: 14 / 30

Section 1: Options & Accessories
Table of Contents
3/28/14 SSP2510, & SSP2512 Snow Pusher 303-348M
10
Section 1: Options & Accessories
Figure 1-1
Pull Back (Optional)
Refer to Figure 1-2:
Land Pride offers an optional pull back blade complete
with mounting hardware for attaching to all models of the
Snow Pusher except model SSP2512. This kit will allow
operator to pull snow away from garage doors while
backing up. See cover for mounting location of pull back.
Pull Back Option
Figure 1-2
37032
Lifting Slots
Attach 2 lift chains to the front
of the side plate to help keep
unit from flipping forward
suddenly while lifting the unit
to its upright position.
NOTE: Rubber snow blade (#7) and retaining
bars (#1 & #2) are shipped from the factory bolted to
pull back frame (#3) with bolts (#5) and nuts (#6).
37179
Part No. Description
303-385A SSP2510 PULL BACK
Skid Steer/Tractor Requirements
The Snow Pusher is designed to attach to skid steer
loaders and tractor loaders equipped with a universal
quick attach hitch with the following requirements:
Hitch type . . . . . . . . . . . . . . . . Universal Quick Attach
Horsepower range: . . . . . . . . . . . . . . . . . . . 50-80 HP
Maximum tractor/skid steer weight:. . . . . . . 8,000 lbs.
Maximum tractor/skid steer lift capacity: . . . 5,000 lbs.
WARNING
!
To avoid serious injury or death:
•
Lightweight power machines may need weight added to the
rear to maintain steering control and prevent forward
tipping or side tipping caused by a heavy front load. Consult
your power machine Operator’s Manual to determine
proper weight requirements and maximum weight
limitations.
•
Power machines outside the listed horsepower range must
not be used. Higher horsepower machines can damage the
attachment. Under horsepower machines makes the job
more difficult and are easier to tip over when loader arms
are raised due to high center of gravity.
Torque Requirements
Refer to “Torque Values Chart” on page 24 to for
correct torque values when tightening hardware.
Dealer Preparations
Ensure that the intended tractor/skid steer conforms to
the requirements stated under the heading
“Skid Steer/
Tractor Requirements” on this page.
Refer to Figure 1-1:
CAUTION
!
To avoid minor or moderate injury:
Keep clear. Snow Pusher can flip forward suddenly causing
serious bodily injury while lifting unit from the crate.
1. The Snow Pusher is shipped on its back. Cut and
remove shipping crate corner posts and top frame.
2. Using a hoist, fork lift, or other lifting device, attach
lifting chains to the two lifting slots at the back and to
the front of the two side plates.
3. Slowly lift unit until it has rotated upright.
4. Lower unit down slowly until resting on its skid shoes.
Accessories are easier to attach after hooking-up Snow
Pusher to a tractor or skid steer. Refer to
“Hooking-Up
The Snow Pusher” on page 15 for detailed instructions.