Section 1: Assembly & Set-Up
11/6/18
7
Section 1: Assembly & Set-Up
Tractor Requirements
The SGC0554 Claw Grapple is designed for attaching to
Kubota’s BX80 Series tractors fitted with BX loader with
2 lever quick coupler. Tractors outside the horsepower
and weight range must not be used.
Horsepower range . . . . . . . . . . . . . . . . . . . . 17-26 hp
Tractor weight. . . . . . . . . . . . . . . . 1300-1600 lbs max.
Loader outlets . . . . . . 2 Quick connect male couplers
BX loader type
. . . . . . LA340S or LA344 with 2 lever quick coupler
WARNING
!
To avoid serious injury or death:
Lightweight tractors with rear attached implements may need
weights added to the front to maintain steering control.
Consult your tractor Operator’s Manual to determine proper
weight requirements and maximum weight limitations.
Torque Requirements
Refer to
“Torque Values Chart”
on page 21 to determine
correct torque values when tightening hardware.
Before You Start
Make sure the intended tractor conforms to the
requirements provided on this page. Also, read and
understand this Operator’s Manual for your Claw
Grapple. An understanding of how it works will aid in its
assembly and set-up.
Go through the
before assembling the Claw Grapple. To speed up your
assembly task and make the job safer, have all needed
parts and equipment readily at hand.
Assembly Checklist
Check
Ref.
Have a fork lift or loader with properly sized chains capable of
lifting the equipment on hand.
Make sure all major components and loose
parts are shipped with the attachment.
Assembly
& Set-up
Double check to make sure all parts, fasteners,
and pins are installed in the correct location.
Refer to the Parts Manual if unsure.
Parts Manual
380-275P
Make sure working parts move freely, and
bolts are tight.
Operator’s
Manual
Make sure all safety labels are correctly
located and legible. Replace if damaged.
Tractor Shut Down Procedure
Power Machine Shutdown Procedure
The following are basic power machine shutdown
procedures. Follow these procedures and any additional
shutdown procedures provided in your power machine
Operator’s Manual before leaving the operator’s seat.
1.
Reduce engine speed and shut-off all power to the
attachment.
2. Park on solid, level ground and lower attachment until
it is flat on the ground or on non-concrete support
blocks.
3. If shutting down a tractor, put tractor in park or set
park brake.
4. Turn off engine, and remove switch key to prevent
unauthorized starting.
5. Relieve all hydraulic pressures.
6. If included, raise seat bar and move controls until
both lock.
7.
Wait for all components to come to a complete stop
before leaving the operator’s seat.
8. Use steps, grab-handles, and anti-slip surfaces
when stepping on and off the power machine.
