Land Pride RTR1574, Руководство оператора

Страница: 21 / 38

Section 1: Assembly & Set-Up
Table of Contents
1/19/21 RTR1574 S/N+ Rotary Tiller 311-431M
17
Driveline Maximum Length
Figure 1-11
Check Driveline Maximum Length
Refer to Figure 1-11:
Driveline maximum length must, when fully extended,
have 1/3 overlap of the profile tubes with both inner and
outer profile tubes being of equal length as shown in
Figure 1-11. Check driveline maximum allowable length
as follows:
1. Make sure
“Check Driveline Collapsible Length”
on page 16 has been completed before continuing
with instructions below.
2. Unhook driveline profiles from the tractor and
implement.
3. If profiles are assembled together, pull outer and
inner drivelines profiles apart.
4. Measure and record “Free Length” of inner and outer
profiles as shown in Figure 1-11.
5. Lubricate driveline u-joints, bearings, and profiles.
Refer to
“Lubrication Points”
on page 27.
6. Assemble driveline halves together until profile tubes
have exactly 1/3 profile overlap as shown.
7. Measure driveline “Maximum Allowable Length” and
record that length here ______.
8. Start tractor, raise implement slightly, and drive
forward enough to clear support blocks.
9. Lower implement to ground and shut tractor down
before dismounting. Refer to
“Tractor Shutdown
Procedure” on page 9.
10. Continue with
“Driveline Hook-Up”
on page 14.
24513
Outer Shielding has been removed for clarity.
IMPORTANT:
The driveline must be lubricated
before putting it into service. Refer to “Lubrication
Points”
on page 27.