Land Pride RTA2064, Руководство оператора, Страница: 14 / 36

Section 1: Assembly & Set-Up
Table of Contents
RTA2064, RTA2072, RTR2064 & RTR2072 Rotary Tillers 311-328M 12/19/18
10
5. Relieve all hydraulic pressure to auxiliary hydraulic
lines.
6. Wait for all components to come to a complete stop
before leaving the operator’s seat.
7. Use steps, grab-handles and anti-slip surfaces when
stepping on and off the tractor.
Driveline Installation
Refer to Figure 1-2, Figure 1-3 & Figure 1-4:
The tiller driveline is coupled to the tractor and implement
shafts with either push pin couplers, pull collar couplers
or a combination of both, and with either a shear bolt or
slip clutch on one end for protection from shock loads.
Always engage power take-off at low engine rpm to
minimize start-up torque.
Drivelines with friction slip
clutches must go through a “run-in” operation prior
to initial use and after long periods of inactivity
. See
“Driveline Protection” on page 20 for detailed
instructions on maintaining the slip clutch.
If Rotary Tiller is used on more than one tractor, an
additional driveline may be required - especially if a quick
hitch is used.
Refer to Figure 1-5 on page 11:
1. Remove gearbox shaft protector (#3) from end of
gearbox shaft.
2. Pull on the pull collar or push on the push pin (#2)
and slide slip clutch or shear bolt end of driveline (#1)
over the gearbox input shaft.
3. Release the pull collar or push pin (#2) and continue
to push the driveline onto the gearbox shaft until the
pull collar or push pin pops out and locks in place.
4. Push/pull on slip-clutch or shear bolt yoke end of
driveline (#1) to ensure it is securely fastened to the
gearbox input shaft.
5. Continue with “Tractor Hook-Up” on page 12.
IMPORTANT: The driveline must be lubricated
before putting it into service. Refer to “Lubrication
Points” on page 24 for detailed instructions.
IMPORTANT: Drivelines with friction clutches must
go through a “run-in” operation prior to initial use and
after long periods of inactivity.See
“Driveline
Protection” on page 20 for detailed instructions.
IMPORTANT: An additional driveline may be
required if implement will be attached to more than
one tractor.
Figure 1-2
Figure 1-3
Figure 1-4
Implement End
Tractor End
Push Pin Coupling
Pull Collar Coupling
With
Slip Clutch Protection
22234
Implement End
Tractor End
Pull Collar Coupling
Pull Collar Coupling
With
Slip Clutch Protection
22235
Implement End
Tractor End
Push Pin Coupling
Push Pin Coupling
With
Shear Bolt Protection
22232