21
7/25/13
RTA10 & RTA15 Series Rotary Tillers 311-252M
Section 4: Maintenance & Lubrication
Section 4: Maintenance & Lubrication
Maintenance
Proper servicing and adjustment is the key to the long life
of any implement. With careful inspection and routine
maintenance, you can avoid costly downtime and repair.
The parts on your Rotary Tiller have been specially
designed and should only be replaced with genuine Land
Pride parts. Do not alter the tiller in a way which will
adversely affect its performance.
Check all bolts and pins after using the unit for several
hours and on a regular basis thereafter to ensure they
are tight and secured.
Replace worn, damaged, or illegible safety labels by
obtaining new labels from your Land Pride dealer.
!
CAUTION
Tine Replacement
Refer to Figure 4-1:
!
WARNING
1.
Remove the 2 hex head cap screws and fasteners
from the tine being replaced and then remove tine.
2.
Attach new tine to the mounting flange making
certain it is positioned so that the cutting edge
crosses over the mounting flange and leads in
rotation as shown in Figure 4-1.
3.
Replace removed cap screws and nuts. Tighten nuts
to the proper torque.
4.
Repeat steps 1 to 3 until tines have been replaced.
TIne Replacement
Figure 4-1
IMPORTANT: Remove and install one tine at a time
to ensure they are oriented correctly when installed.
30052
Driveline Protection
Tiller drive components are protected from shock loads
with either a two plate friction clutch or a shear bolt.
Shear bolt protection is discussed on page 23.
Friction clutches should be “run-in” prior to initial
operation and after long periods of inactivity to remove
any oxidation that may have accumulated on the friction
surfaces. Repeat “run-in” instructions at the beginning of
each season and when moisture and/or condensation
seizes the inner friction plates.
Refer to Figure 4-2 below and Figure 4-3 on page 23 to
determine which friction clutch your tiller has. Follow
run-In, disassembly, and assembly instructions for your
specific clutch.
Clutches With 4 Adjusting Nuts
Clutch Run-In
Refer to Figure 4-2 (View - A):
1.
Using a pencil or other marker, scribe a line across the
exposed edges of the clutch plates and friction disks.
2.
Tighten all 4 nuts uniformly until spring load is low
enough that the clutch slips freely with PTO
engaged.
Clutches With 4 Adjusting Nuts
Figure 4-2
3.
Start tractor and engage PTO for 2-3 seconds to
permit slippage of clutch surfaces. Disengage PTO,
then re-engage a second time for 2-3 seconds.
Disengage PTO, shut off tractor, and remove key.
Wait for all components to stop before dismounting
from tractor.
4.
Inspect clutch and ensure that the scribed markings
made on the clutch plates have changed position.
Slippage has not occurred if any two marks on the
friction disk and plate are still aligned. A clutch that
has not slipped must be disassembled to separate
the friction disk plates. See “Clutch Disassembly &
Assembly” on page 22.
Refer to Figure 4-2 (View - B):
5.
Turn all 4 nuts fully back if no two marks on the
friction disk and plate are still aligned. Clutch is ready
for use.
6.
The clutch should be checked during first hour of
tilling and periodically each week. An additional set
of scribe marks can be added to check for slippage.
23696
