Land Pride RGA12 Series, Руководство оператора

Страница: 27 / 40

Section 4: Maintenance and Lubrication
Table of Contents
RGR12 & RGA12 Series Rotary Tillers 311-948M 1/7/19
23
Section 4: Maintenance and Lubrication
Maintenance
Proper servicing and adjustments are key to the long life
of any implement. With careful inspection and routine
maintenance, you can avoid costly downtime and repair.
Check all hardware after several hours of operation and
regularly thereafter to ensure they are tight and secured.
Replace worn, damaged, or illegible safety labels by
obtaining new labels from your Land Pride dealer.
DANGER
!
To avoid serious injury or death:
•
Always secure equipment with solid, non-concrete supports
before working under it. Never go under equipment
supported by concrete blocks or hydraulics. Concrete can
break, hydraulic lines can burst, and/or hydraulic controls
can be actuated even when power to hydraulics is off.
WARNING
!
To avoid serious injury or death:
•
Allow only persons to perform maintenance on this
implement who have been properly trained in its safe
operation.
•
Before any adjustments or maintenance is performed, lower
implement to ground, shut engine off, and remove switch
key. Do not attempt to make adjustments or perform
maintenance with implement or power machine running.
•
Do not alter implement or replace parts on the implement
with other brands. Other brands may not fit properly or
meet OEM (Original Equipment Manufacturer)
specifications. They can weaken the integrity and impair the
safety, function, performance, and life of the implement.
Replace parts only with genuine OEM parts.
Tine Replacement
Refer to Figure 4-1 for RGR12 Series Tillers and
Figure 4-2 for RGA12 Series Tillers:
WARNING
!
To avoid serious injury or death:
Used tines can be very sharp. Always wear gloves when
handling tines to protect against cuts.
1. Remove the two hex nuts (#4), lock washers (#3),
bolts (#1), and tine (#2) to be replaced.
IMPORTANT: When ordering tines, be sure to order
only genuine OEM tines and to order both right- and
left-hand tines. Always install tines with cutting edge
facing the direction of rotation.
IMPORTANT: Remove and install one tine at a time
to ensure they are oriented correctly when installed.
RGR12 Series Tine Replacement
Figure 4-1
RGA12 Series Tine Replacement
Figure 4-2
2. Attach new tine (#2) to the mounting flange making
certain it is positioned so that the cutting edge
crosses over the mounting flange and leads in
rotation as shown in Figure 4-1 for the RGR12 Series
or in Figure 4-2 for the RGA12 Series.
3. Replace removed 1/2"-20 x 1 1/4" GR5 bolts (#1),
lock washers (#3), and hex nuts (#4). Tighten hex
nuts to the correct torque.
4. Repeat steps 1 to 3 until all tines have been replaced.
70291
Cutting Edge
Cutting Edge
Direction of Tine Rotation
70297
Direction of Tine Rotation
Cutting Edge
Cutting Edge