Land Pride RCM3712, Руководство оператора

Страница: 27 / 64

Section 1: Assembly & Set-up
RC(M)3712 & RCG(M)3712 Rotary Cutters 334-203M 11/6/18
23
Table of Contents
Hook-up LED Lights
Refer to Figure 1-24:
The lead wiring harness (#13) is equipped with a 7-way
round pin connector for connecting to the tractor’s 7-pin
electrical outlet shown in Figure 1-25.
1. Route lead wire harness (#13) through spring hose
loops (not shown).
2. Connect lead wire harness (#13) to the tractor’s
7-way round pin receiver.
3. It is best to have a second person verify the lights are
operating. Start tractor and operate lights as follows:
a. Turn on head lights to verify red lights illuminate.
b. Turn on flasher lights to verify amber lights are
blinking on and off.
4. If the lights did not operate properly, recheck hook-up
of enhance module and wire harnesses. Make
necessary changes and repeat step 3 above.
5. Check wire harness routing to make sure wires will
not be pinched as wing decks are folded and
unfolded and while raising and lowering cutter height.
6. Secure harness in place with spiral hose wrap (#12)
and add cable ties as needed.
LED Hookup (Standard Clevis Hitch Shown)
Figure 1-24
Tractor 7-Pin Electrical Outlet
Figure 1-25
70460
Remove Shipping Lugs
Refer to Figure 1-26:
Tie down lugs are installed on the rear two corners of the
center deck for shipping purposes only. They should be
removed and discarded before cutter is put into use.
Remove and discard both shipping lugs (#1) and
attaching hardware (#2 & #3).
Rear Shipping Lugs Removal
Figure 1-26
70470