Land Pride RCG3715, Руководство оператора

Страница: 30 / 66

Section 1: Assembly & Set-up
RC(M)3715 & RCG(M)3715 Rotary Cutters 334-114M 1/26/21
26
Table of Contents
Hook-up LED Lights
Refer to Figure 1-27:
The lead wiring harness (#13) is equipped with a 7-pin
plug for connecting to the tractor’s 7-pin electrical outlet
shown in Figure 1-28.
1. Route lead wire harness (#13) through the front and
rear spring hose loops (#14).
2. Connect plug on lead wire harness (#13) to the
tractor’s 7-pin electrical outlet.
3. It is best to have a second person to verify the lights
are operating. Start tractor and operate lights as
follows:
a. Turn on headlights to verify red lights illuminate.
b. Turn on flasher lights to verify amber lights are
blinking on and off.
Refer to Figure 1-29:
4. If the lights did not operate properly, recheck hook-up
of the enhance module (#9) and wire harnesses
(#8 & #13) as outlined below. Make any necessary
changes and repeat step 3 above.
a. Reference wire harness (#8) leading to the LED
lights on the right-hand side of the cutter. Make
sure connector (#8R), labeled “ENHANCER”, is
connected to the Red wire connector (#9R) on
enhancer module (#9).
a. Reference wire harness (#8) leading to the LED
lights on the left-hand side of the cutter. Make
sure connector (#8L), labeled “ENHANCER”, is
connected to the Yellow wire connector (#9L) on
enhancer module (#9).
b. Make sure lead wire harness (#13) is connected
to connector (#9C) on enhancer module (#9).
c.
Refer to Figure 1-27:
Ensure that the 7-pin plug
on the end of the 15' lead wire harness (#13) is
properly seated in the tractor’s 7-pin electrical
outlet shown in Figure 1-28.
5. Check routing of wire harness (#8) to make sure they
will not be pinched as the arms fold and unfold and
while raising and lowering the cutter height.
Refer to Figure 1-27:
6. Check routing of lead wire harness (#13) to make
sure it pass through the spring hose loop (#14).
7. Secure harness in place with spiral hose wrap (#12).
If needed, add any cable ties to complete the
process.
Remove Shipping Lugs
Refer to Figure 1-30:
Tie down lugs are installed on the rear two corners of the
center deck for shipping purposes only. They should be
removed and discarded before cutter is put into use.
Remove and discard both shipping lugs (#1) and
attaching hardware (#2 & #3).
LED Hookup (Standard Clevis Hitch Shown)
Figure 1-27
Tractor 7-Pin Electrical Outlet
Figure 1-28
Enhance Module Wire Connections
Figure 1-29
Rear Shipping Lugs Removal
Figure 1-30
70460
72210
Has a Yellow Wire
Has a Red Wire
70511