Land Pride RCG3715, Руководство оператора

Страница: 20 / 66

Section 1: Assembly & Set-up
RC(M)3715 & RCG(M)3715 Rotary Cutters 334-114M 1/26/21
16
Table of Contents
Swivel Clevis Hitch Hook-up
DANGER
!
To avoid serious injury or death: A crushing hazard exists
while hooking-up and unhooking the implement. Keep people
and animals away while backing-up to the implement or
pulling away from the implement. Do not operate hydraulic
controls while a person or animal is directly behind the power
machine or near the implement.
WARNING
!
To avoid serious injury or death: The ball detent pin must be
fully inserted into the park jack with ball visible and popped
out on the far side of the jack before working on or around an
unhooked cutter.
Refer to Refer to Figure 1-9:
1. Make certain park jack (#3) is properly attached
to the cutter hitch and secured with detent pin (#8). If
park jack is not vertical, refer to “Park Jack Angle
Alignment”
on page 29.
2. Store center 3-point link in its storage hook.
3. Start tractor and raise 3-point arms fully up.
4. Carefully back tractor within close proximity of
clevis (#9).
5. Shut tractor down properly before dismounting. Refer
to
“Tractor Shutdown Procedure”
on page 15.
6. Verify tractor drawbar is adjusted correctly. Refer to
“Drawbar Set-up”
dimensions on page 13.
7. Raise or lower park jack (#3) to align clevis (#9) with
tractor drawbar. Drawbar should fit between lower
and upper plates of clevis.
8. Restart tractor and continue to back tractor up to
cutter hitch until hitch holes in tractor drawbar and
hitch clevis (#9) are aligned.
9. Shut tractor down properly before dismounting.
10. Attach cutter to tractor drawbar with customer
supplied hitch pin (#1) and hairpin cotter (#2).
11. Lower park jack (#3) until hitch weight is supported
by drawbar.
12. Remove park jack (#3) from hitch and attach it to the
left-hand wing storage base with detent pin (#8).
Make sure base is level with or lower than the head
especially after the wings are folded up. See cover
picture for correct positioning.
13. Attach hitch safety chain (#4) to tractor. Adjust chain
length to remove all slack except what is necessary
to permit turning. Lock chain hook securely to the
safety chain.
14. Continue with “Hydraulic Hook-up” on page 19.
NOTE: Hitch pin (#1) and hairpin cotter (#2) are
supplied by customer.
IMPORTANT:
Before moving the cutter, relocate
park jack by storing it on the left wing deck. Make
sure the jack is stored with its base level or lower
than the head to prevent water and freeze damage.
Swivel Clevis Hitch Hook-up
Figure 1-9
37298 74879