Land Pride RCF3684, Руководство оператора

Страница: 18 / 56

14
Section 1: Assembly & Set-Up
RCF3684 Rotary Cutters 326-412M
Table of Contents
11/13/18
Hydraulic Hook-up (3-Point)
WARNING
!
To avoid serious injury or death:
Hydraulic fluid under high pressure can penetrate the skin
and/or eyes causing a serious injury. Wear protective gloves
and safety glasses or goggles when working with hydraulic
systems. Use a piece of cardboard or wood rather than hands
when searching for leaks. A doctor familiar with this type of
injury must treat the injury within a few hours or gangrene
may result. DO NOT DELAY.
Refer to Figure 1-9 on page 12:
1. Make sure spring support loop (#10) is securely
fastened to the hitch frame.
2. Route hydraulic hoses (#12 & #13) through spring
support loop (#10) and connect to tractor outlets.
3. Cycle hydraulic lift cylinder as follows:
a. Fully extend hydraulic lift cylinder and hold control
lever in the extended position for 20 seconds after
hydraulic cylinder has fully extended.
b. Fully retract hydraulic lift cylinder and hold control
lever in the retracted position for 20 seconds after
hydraulic cylinder has fully retracted.
c. Repeat steps a-b above until hydraulic cylinder
operates smoothly.
4. Continue with “Check Driveline Interference” on
page 16.
Check Driveline Minimum Length
Figure 1-10
Check Driveline Collapsible Length
1. With driveline attached only to the cutter, remove
outer driveline (tractor end) from inner driveline to
separate the two profiles.
2. Park tractor and cutter on a level surface.
3. Raise cutter until gearbox input shaft is level with
tractor power take-off shaft. Securely block cutter at
this height to keep the unit from lowering.
4. With cutter resting on the support blocks, shutdown
the tractor using “Tractor Shutdown Procedure” on
page 33.
5. Attach outer driveline to the tractor’s power take-off
shaft. Refer to step 6 under “Driveline Hook-up (3-
Point)” .
6. Hold inner and outer drivelines parallel to each other
as shown in Figure 1-10. Measure dimension “A”.
•
If “A” is less than 1", continue with step 7 on
page 15.
•
If “A” is greater than or equal to 1", skip to “Check
Driveline Maximum Length” on page 15.
33049
IMPORTANT: A driveline that is too long can bottom
out causing structural damage to the tractor and
implement. Always check driveline minimum length
during initial setup, when connecting to a different
tractor, and when alternating between using a quick
hitch and a standard 3-point hitch. More than one
driveline may be required to fit all applications.