Land Pride RCF3096, Руководство оператора

Страница: 39 / 76

Section 2: Assembly of Optional Equipment
Table of Contents
RCF3096, RCF3010, & RCFM3010 Rotary Cutters 326-566M 11/8/18
35
Rubber Safety Guards (Optional)
DANGER
!
To avoid serious injury or death:
Rotary Cutters have the ability to discharge objects at high
speeds; therefore, the use of front and rear safety guards is
mandatory when cutting along roadways and in areas where
people may be present. Stop blade rotation if a bystander is in
or around the area.
WARNING
!
To avoid serious injury or death:
Keep all safety guards in place. Rotary Cutters have the
ability to discharge objects at high speeds. Use extreme
caution when cutting in areas where people may be present. It
is best to operate the cutter when no one is nearby. Stop blade
rotation if someone is in or around the area.
Front Rubber Guards
Refer to Figure 2-4:
1. Attach front Rubber Deflectors (#1) as shown with
1/2"-13 x 1" carriage bolts (#2) and whiz nuts (#3).
2. Attach reflector bracket (#4) with 1/2"-13 x 1 1/2" long
carriage bolts (#5) and hex whiz nuts (#3).
3. If Constant Velocity driveline is included, attach
bearing support to front rubber guards using
steps 1 & 2 on page 31 for installation instructions.
NOTE: Do not tighten hardware until assemblies
are complete.
NOTE: The two carriage bolts “A” are not used if CV
driveline option is included. See “Constant Velocity
Driveline (Pull-Type)” on page 31.
4. Tighten hex whiz nuts (#3) to the correct torque.
Rear Rubber Guard
Refer to Figure 2-3:
1. Attach rear rubber guard (#5), rear guard strap (#1),
and if included, rear foot guards (#2) to the deck rear
with 1/2"-13 x 1 1/2" long carriage bolts (#3), and hex
whiz nuts (#4).
2. Tighten hex whiz nuts (#3) to the correct torque.
Rear Rubber Guard (RCF3096 Shown)
Figure 2-3
NOTE: Rear foot guards (#2) are included only with
the RCF3096 Model. They are not included with
RCF3010 & RCFM3010 Models.
35052
Front Rubber Guard (RCF3096 Shown)
Figure 2-4
35073