Land Pride QuickHitch RBT35 Series, Руководство оператора

Страница: 25 / 40

Section 2: Options, Assembly & Set-Up
Table of Contents
1/13/21 RBT3584 & RBT3596 Rear Blades 301-251M
21
2. Position hydraulic cylinder (#7) with ports on top as
shown. Thread 90 degree elbows (#9) into the two
ports and tighten.
3. Screw 116" long hydraulic hoses (#10 & #11) onto
elbows (#9) and tighten.
4. Thread adapter fittings (#8) to other end of hydraulic
hoses and tighten. (Customer to supply quick
disconnect hydraulic couplings.)
5. Attach hydraulic cylinder to mounting lugs on the
gauge wheel with two 1" clevis pins (#6). Make sure
hydraulic ports are positioned on top and cylinder
base is located facing forward as shown.
6. Secure clevis pins with hair pin cotters (#5).
7.
Thread hydraulic hoses through the two hose
retainers.
IMPORTANT:
Attach cylinder base to the front
mounting lug. The base will interfere with the gauge
wheel arm if attached to the rear mounting lug.
Single Gauge Wheel (Accessory)
Refer to Figure 2-11:
Ratchet Jack Option
1. Attach gauge wheel (#1) to back mounting plate with
four 3/8"-16 GR5 hex head cap screws (#2), lock
spring washers (#4), and nuts (#3). Tighten nuts to
the correct torque.
2. Attach ratchet jack (#12) to mounting lugs on gauge
wheel (#1) with two 1" clevis pins (#6). Secure with
hair pin cotters (#5).
Hydraulic Cylinder Option
1. Attach gauge wheel (#1) to back mounting plate with
four 3/8"-16 GR5 hex head cap screws (#2), lock
spring washers (#4), and nuts (#3). Tighten nuts to
the correct torque.
IMPORTANT:
The top center 3-Point link should be
removed from the blade and tractor before using
gauge wheel accessory.
Single Gauge Wheel Assembly
Figure 2-11
24803
Customer to supply Quick
Disconnect Couplings.