27
Section 3: Adjustments
2/10/09
ZXT54 & ZXT60 Pro Series Zero Turning Radius Mowers Riding Mowers 357-271M
Land Pride
Refer to Figure 3-11:
6.
Loosen jam nut (#3) and back it away from deck lift
block (#1) approximately 1".
7.
Turn adjusting nut (#2) several truns away from deck
lift block (#1).
Deck Height Gauge Bar Adjustment
Figure 3-11
Refer to Figure 3-12 & Figure 3-13:
8.
Unscrew jam nut (#11) from trunnion block (#9) four
or more turns. Typical both sides.
9.
Unscrew adjusting nut (#10) from trunnion block (#9)
approximately 1". Typical both sides.
Refer to Figure 3-11 & Figure 3-13:
10. Loosen 5/16” jam nut (#16). Back adjuster bolt (#15)
out until adjuster (#17) can move up and down freely.
11. Set cutting height at 3 1/4” by turning deck height
adjusting stop (#5) so that the flat side is against stop
handle (#4) and then place adjusting stop into the 3”
cutting height hole in deck height gauge bar (#6)
(See deck height indicator (#7) to locate 3" hole.)
Refer to Figure 3-11 & Figure 3-12:
12. Turn adjusting nut (#2) against deck lift block (#1)
until front deck lift chain (#14) on the left side is tight
and deck is still resting on the 3" support blocks.
13. Tighten jam nut (#3) against deck lift block (#1).
IMPORTANT: Deck lift rod connection at the rear is
fixed and is not adjustable. All adjustments to level
and set deck height must be made at the front.
25864
4
5
6
7
8
1
2
3
Deck Level Adjustment (Left Side)
Figure 3-12
Refer to Figure 3-12 & Figure 3-13:
14. Be sure adjuster (#17) is free to move up and down.
Tighten adjuster bolt (#15) until front deck lift chain
on the right side becomes tight. Make sure mower
deck stays tight against 3” support blocks.
15. Tighten jam nut (#16).
16. Turn adjusting nut (#10) against trunnion block (#9)
until it makes contact. Typical both sides.
17. Tighten jam nut (#11) against trunnion block (#9).
Typical both sides.
Deck Level Adjustment (Right Side)
Figure 3-13
25863
9
11
10
12
14
13
25870
13
4
5
11
10
9
18
17
12
6
15
16
