8
Section 1: Assembly & Set-up
PR2572 & PR2596 Powered Rakes 314-132M
6/06/06
Land Pride
Table of Contents
4.
Remove the friction clutch (#7) that is assembled to
the front of the front frame drive shaft (#8). (It is
assembled here for shipping only.) Assemble the
friction clutch to the rear of the front frame drive shaft
and gearbox as shown. Refer to Figure 1-2
Friction Clutch Alignment
Figure 1-2
10611
Section 1: Assembly & Set-up
Gauge Wheel and Frame Assembly
Figure 1-1
Tractor Requirements
This powered rake is designed with a 3-Point category I
hitch. Horse power rating of tractor should not exceed 50
PTO horse power on all PR2572 & PR2596 Powered
Rakes.
!
CAUTION
DO NOT OVER SPEED PTO OR MACHINE DAMAGE MAY
RESULT. THIS POWERED RAKE IS DESIGNED TO BE
USED WITH A TRACTOR USING A 540 RPM REAR PTO.
Gauge Wheel and Frame Assembly
Refer to Figure 1-1:
1.
Install the rear gauge wheels (#1) to the rear frame
(#6) as shown. Secure with the wire pins (#2).
2.
Remove the main pivot castings (#3) and (#4) from
the rear frame (#6).
3.
Install the front frame (#5) to the rear frame (#6)
using the pivot castings that were removed
previously.
IMPORTANT:
In order to maintain steering control,
ballast may have to be added to the front end of your
tractor. To determine whether or not to add ballast,
refer to your tractor operator’s manual.
