57
Section 8: Maintenance & Lubrication
NTS2507, NTS2509, & NTS2511 No-Till Seeder 313-629M
3/6/18
10. Adjust roller wheels (#3) and roller clamps (#2) as
follows:
NTS2507
a. Slide all roller wheels (#3) and roller clamps (#2)
towards the center of the rear packer roller
assembly until all slack is removed.
NTS2509
a. On the left-hand rear packer roller assembly, slide
all roller wheels (#3) and end roller clamps (#2)
toward the center roller clamp until all slack is
removed. Not to exceed clearance space
provided in rear scraper bar.
b. Repeat step a above for the right-hand rear
packer roller assembly.
NTS2511
a. On the left-hand rear packer roller assembly, slide
all roller wheels (#3) and roller clamps (#2) toward
the center until all slack is removed. Not to exceed
clearance space provided in rear scraper bar.
b. Repeat step a above for the right-hand rear
packer roller assembly.
11. Tighten all 3/8"-16 hex nuts (#1) to the proper torque.
12. Restart tractor and raise seeder up. Pull ahead
several feet and lower seeder down to the ground.
13. Shut tractor engine off and remove switch key.
14. Store support blocks for future roller wheel
adjustments.
Front Spike Rollers
The front spike rollers should turn freely. If they do not,
investigate and remove the cause.
Trash build-up between spikes can prevent spikes from
penetrating the soil properly. Clean trash from spike
rollers as needed.
Roller Wheel Adjustment (NTS2509 Left-Hand Packer Roller Shown)
Figure 8-8
39446