Section 1: Kit Assembly
5
5/11/23
LX20 Third Function Valve Kit Assembly Instructions Manual No. 380-422M
4. Route wire harness from new control handle (#32)
completely through braided sleeve (H).
5. Guide wire harness and braided sleeve (H) through
top of rubber boot (E), then through rubber boot
opening on upper console cover (F).
6. Install new control handle (#32) onto loader control
lever. Orient control handle (#32) so the two red
buttons (#40) face the front of the tractor.
7.
Secure new control handle (#32) to loader control
lever with two 5/16" set screws (#36). Tighten both
set screws (#36).
8. Secure set screws (#36) with two 5/16" jam
nuts (#38). Tighten both jam nuts (#38).
Assembled Control Handle - Cab Tractor
Figure 1-8
9. Continue routing wire harness from the control lever,
all the way down to the cab floorboard.
10. Ensure wire harness can continue routing out
through cutout (a) on lower console cover (G) as
shown in Figure 1-7 on page 4.
11. Secure wire harness with cable ties (#31) at any
clamping locations marked with white tape.
12. Reinstall both console covers (F & G) to the tractor.
13. Reinstall rubber boot (E) to its original position on
console cover (F).
78738
32
36 & 38
H
40
F
E
Control Handle Assembly for ROPS
Tractors
Refer to Figure 1-9:
1. Remove preexisting control handle (not shown) from
loader control lever.
2. Route wire harness from new control handle (#32)
completely through braided sleeve (H).
3. Install new control handle (#32) onto loader control
lever. Orient control handle (#32) so both red
buttons (#40) face the front of the tractor.
4. Continue routing wire harness down the control lever,
securing it with cable ties (#31) as shown in
5. Secure new control handle (#32) to loader control
lever with two 5/16" set screws (#36). Tighten both
set screws (#36).
6. Secure set screws (#36) with two 5/16" jam
nuts (#38). Tighten both jam nuts (#38).
Assembled Control Handle - ROPS Tractor
Figure 1-9
78771
32
40
H
36 & 38
31
