Land Pride LR16 Series, Руководство оператора, Страница: 16 / 30

Section 2: Accessory Equipment Set-up
Table of Contents
LR1660, LR1672, LR1684 & LR1696, LR2684 & LR2696 Landscape Rakes 302-305M 11/27/18
12
12. Attach rod end of hydraulic cylinder (#14) to rear
cylinder mount (#5) with clevis pin (#2) and hairpin
clip (#1).
Dual Gauge Wheel Installation
Refer to Figure 2-2:
1. Attach gauge wheel support arm (#2) on the right-
hand side of rake mount (#3) with six 3/8"-16 x 2 3/4"
GR5 hex head cap screws (#4), interior/exterior
toothed lock washers (#6), and hex nuts (#5) as
shown. Tighten to proper torque.
2. Insert two bushings (#8) into gauge wheel arm (#2)
as shown.
3. Insert yoke spindle (#1) through two 1" spacers
(#10), inserted bushings (#8), two 1" Spacers (#10),
and
1/2" spacer (#9) as shown. Secure with wire retaining
pin (#7). Make certain wire retainer is fastened over
end of pin.
4. Repeat steps 1 through 3 to attach gauge wheel
assembly on the left-hand side of rake.
Grader Blade Installation
The grader blade can be attached directly to the dual
gauge wheel arms. If gauge wheels are not installed,
grader blade support arms must be purchased and
mounted to the rake before the blade can be installed.
Grader Blade Set-up with Gauge Wheels
Refer to Figure 2-3:
1. Refer to “Dual Gauge Wheel Installation” steps 1-4
on this page to assemble Dual Gauge Wheels.
2. Attach blade lock handle (#1) to the right and left-
hand Gauge Wheel Arms (#3) with 1/2" x 3" GR5 hex
bolts (#4), lock washers (#8), and hex nuts (#6) as
shown. Tighten to proper torque.
3. Insert bent pins (#9) through top hole of gauge wheel
arms (#3). Secure with hairpin cotters (#10).
4. Attach both right and left sides of grader blade (#2) to
gauge wheel arms (#3) with 3/4"-10 x 2 3/4" GR5 hex
bolts (#5) and locknuts (#7) as shown. Draw locknuts
up snug, do not tighten.
5. Refer to “Side Plate Assembly to Grader Blade” on
page 13 for attaching side plates to both ends of
grader blade.
NOTE: The gauge wheels are set-in from the end
about 1 1/2" on the 60" & 72" rakes and about 7 1/2"
from the end on the 84" & 96" rakes.
NOTE: See “Grader Blade Set-up without Gauge
Wheels” on page 13 if Dual Gauge Wheels are not
installed.
Gauge Wheel Assembly
Right-Hand Assembly Shown
Figure 2-2
Grader Blade Assembly with Gauge Wheel
Right-Hand Side Shown
Figure 2-3
33840
33841