Land Pride GR1525, Руководство оператора

Страница: 20 / 44

Section 1: Assembly & Set-up
GR1525 Stump Grinder 328-167M 3/17/20
16
Table of Contents
Three Point Hook-up
Refer to Figure 1-7:
1. If hooking-up with a Quick Hitch, refer to the Quick
Hitch Operator’s Manual for detailed hook-up and
operating instructions. Otherwise, continue with
step 2 below.
2. Slowly back tractor up to the Stump Grinder while
using the tractor’s 3-point control lever to align holes
in the tractor’s lower 3-point lift arms with hitch
pins (#2).
3. Shut tractor down according to
“Tractor Shutdown
Procedure” on page 12.
4. Attach lower 3-point lift arms to hitch pins (#2) and
secure with customer supplied linchpins (#1).
5. Connect top center 3-point link to the upper hitch
clevis with customer supplied hitch pin (#4). Secure
hitch pin with customer supplied hitch pin
keeper (#3).
Refer to Figure 1-8:
6. Start tractor and raise grinder until park stand (#1) is
off the ground 4-5 inches.
7. Without changing the 3-point lift height, shut tractor
down according to “Tractor Shutdown Procedure”
on page 12.
8. Remove wire retaining pin (#2) and park stand (#1)
from its parked position. Flip park stand over and
position as shown in the stored position.
9. Reinsert wire retaining pin (#2).
10. Hook wire retainer over end of pin to secure the park
stand.
NOTE:
Cat. I hitch pins shown. Cat II hitch pins are
mounted positioned outside of tabs (B).
Parking Stand
Figure 1-8
11. Ensure lower 3-point lift arms are stabilized to
prevent excessive side-to-side movement. Consult
your tractor Operator’s Manual for detailed
instructions.
12. Adjust one of the lower 3-point arms up or down to
level the mainframe. The mainframe will be level
when both sides of the frame are equal distance from
the ground.
13. Start the tractor and slowly operate tractor
3-point hydraulic control lever to slowly raise and
lower the Stump Grinder while checking for
clearance between tractor tires and drawbar. Move
or remove drawbar if it interferes with any part of the
Stump Grinder.
14. Lower 3-point until unit is resting on the ground.
15. Shut tractor down before dismounting. Refer to
“Tractor Shutdown Procedure” on page 12.
16. Lengthen or shorten the top center link to adjust the
main frame vertical.
Stored Parked
73293 73222
Tractor Hook-Up (Cat. I shown)
Figure 1-7
37298
73192