Land Pride GR1525, Руководство оператора

Страница: 19 / 44

Section 1: Assembly & Set-up
GR1525 Stump Grinder 328-167M 3/17/20
15
Table of Contents
Hitch Pin Installation
Refer to Figure 1-6:
DANGER
!
To avoid serious injury or death:
Always secure equipment with solid, non-concrete supports
before working under it. Never go under equipment supported
by concrete blocks or hydraulics. Concrete can break,
hydraulic lines can burst, and/or hydraulic controls can be
actuated even when power to hydraulics is off.
WARNING
!
To avoid serious injury or death:
Lightweight tractors with rear attached implements may need
weights added to the front to maintain steering control.
Consult your tractor Operator’s Manual to determine proper
weight requirements and maximum weight limitations.
Category I Hitch Pin Set-up
Refer to Figure 1-6:
1. Remove Cat. II hitch pin (#5) from tabs (B).
2. Remove Cat. I hitch pins (#2) from storage tabs (A).
3. Adjust jam nuts (#8) on Cat. I hitch pins (#2) until
center of linchpin holes are 1 13/16" from the face of
the jam nuts.
4. Insert Cat. I hitch pin (#2) in tab (B) as shown on the
right-hand side. Secure with lock washer (#6) and
hex nut (#7).
5. Tighten hitch pin (#2) by inserting a drive punch in its
linchpin hole and rotating the hitch pin until the
linchpin hole is vertical.
6. Hold linchpin hole vertical and tighten 7/8-14 hex nut
(#7) to the correct torque.
7. Repeat steps 4-6 for the other Cat. I hitch pin.
8. Store Cat. II hitch pins (#5) in tabs (A).
IMPORTANT: The tractor’s lower 3-point arms must
be stabilized to prevent side-to-side movement.
Most tractors have sway blocks or adjustable chains
for this purpose.
NOTE:
Land Pride’s Quick Hitch can be attached to
the tractor to provide quick and easy 3-point hook-
up and detachment. See your nearest Land Pride
dealer to purchase a Quick Hitch.
NOTE: Linchpins (#1), upper center hitch pin (#4),
and hitch pin keeper (#3) are customer supplied.
NOTE: Cat. I hitch pins are mounted positioned
inside of tabs (B). Cat II hitch pins are mounted
positioned outside of tabs (B).
Cat I & Cat II Set-up
Figure 1-6
Category II Hitch Pin Set-up
Refer to Figure 1-6:
1. Remove Cat. I hitch pins (#2) from tabs (B).
2. Remove Cat. II hitch pins (#5) from storage tabs (A).
3. Install washers (#9) onto hitch pins (#5) and insert
hitch pins in tabs (B) as shown on the left-hand side.
4. Secure Cat. II hitch pins (#5) with lock washers (#6)
and nut (#7). Insert a drive punch in the linchpin hole.
Rotate linchpin hole vertical and tighten nuts (#7) to
the correct torque.
5. Store Cat. I hitch pins (#2) in tabs (A).
73309
CAT I CAT II
CAT I
SHOWN
CAT II
SHOWN
Left
Rig
ht