Land Pride GB20 Series, Руководство оператора

Страница: 26 / 36

Section 2: Operating Procedures
GB2084 Grapple Bucket 380-328M 6/16/21
22
Table of Contents
8. Lower grapple until the grapple is supported by park
stands (#3) and tines (#4). If needed, adjust angle of
bucket to make sure park stands and tines are on the
ground.
9. Shut tractor down before dismounting. Refer to
“Tractor Shutdown Procedure” on page 9.
10. Remove linchpins (#5 & #7) and mounting
pins (#6 & #8).
11. Restart tractor and slowly lower bucket (#2) until it is
below towers (#9).
12. Slowly back bucket (#2) away from grapple
towers (#9) until the bucket is free of the grapple.
13. Shut tractor down before dismounting.
14. Replace mounting pins (#6 & #8) in the grapple and
secure with linchpins (#5 & #7).
Unhook From Quick Attach Hitch
Plate
Refer to Figure 2-5:
WARNING
!
To avoid serious injury or death:
Park bucket with grapple tines pointing down and grapple
hydraulic cylinders fully extended.
1. See “Long-Term Storage” on page 25 if parking
bucket for long periods.
2. Shut tractor down before dismounting. Refer to
“Tractor Shutdown Procedure”
on page 9.
3. Disconnect customer supplied hydraulic hoses from
the tractor and store hoses on the bucket.
4. Pull loader hitch lock handles up to remove pins from
the bottom slots in the bucket hitch plate.
5. Return to the tractor and raise bucket up 10".
6. Tilt front of bucket down 5 to 10 degrees below
horizontal and lower bucket until cutting edge is
touching the ground.
7. Slowly lower loader arms until top angle bars and
loader hitch plate have separated.
8. Slowly back tractor away from the bucket while
making sure the front loader does not interfere with
the bucket hitch plate and hydraulic hoses.
Unhook From Quick Attach Hitch Plate (Shown with Grapple Attached)
Figure 2-5
73675