Land Pride FSP700, Руководство оператора

Страница: 11 / 32

7
Section 1: Assembly & Set-up
FSP500, FSP700 & FSP1000 Broadcast Spreaders 309-065M
Table of Contents
11/29/18
Tractor Requirements
Tractor horsepower should be within the range noted
below. Tractors outside the horsepower range must not
be used. 3-Point arms should be stabilized to prevent
side-to-side movement.
Rear Power Requirement Must be capable of 540 rpm
Hitch Type . . . . . . . . . . . . . . . . . . . . . 3 - Point Cat. 1
Spline Size . . . . . . . . . . . . . . . . . . . . . . . . . . 1 3/8" - 6
Gearbox & Spreader Disc Assembly
Refer to Figure 1-1:
1. Attach lower link pins (#2) to main frame (#1) with
lock washers (#3) and nuts (#4). Tighten nuts to the
correct torque.
2. Install gearbox (#5) to main frame with six #8 x 16 hex
socket cap screws (#6). Tighten cap screws to the
correct torque.
3. Install spreader disc (#9) over gearbox (#5) output
shaft and secure with M8 x 14 spring pin (#7). Insert
a second M5 x 40 spring pin (#8) inside the M8 pin.
Gearbox and Spreader Disc Assembly
Figure 1-1
NOTE: Ballast may need to be added to your tractor
to maintain steering control. Refer to your tractor’s
manual to determine if additional ballast is needed.
24971
Poly Hopper Assembly
Refer to Figure 1-2:
1. Attach entrainer (#5) to gearbox output shaft with
M8 x 14 spring pin (#6). Be sure to drive spring pin all
the way in.
2. Orient poly hopper with gate openings positioned on
both sides of the lever mounting bracket.
3. Attach poly hopper (#1) to main frame (#2) with three
M10 x 20 round head cap screws (#3) & M10 nut (#4).
4. Insert lower agitator (#7) over entrainer (#5).
5. Insert rubber ring (#8) over entrainer and press down
against agitator (#7) until agitator is against hopper
bottom.
Poly Hopper Assembly
Figure 1-2
24972
Section 1: Assembly & Set-up