Land Pride BB3578, Руководство оператора

Страница: 14 / 22

Section 3: Adjustments
Table of Contents
BB3578, BB3584, & BB3596 Fixed Bar Box Scraper 303-398M 11/7/18
10
Shank Adjustments
Figure 3-1
Top Shank Hole:
Shank Tip is 4" Below Bottom of Side Plates
Third Shank Hole:
Shank Tip is Even with Bottom of Side Plates
Second Shank Hole:
Shank Tip is 2" Below Bottom of Side Plates
Fourth Shank Hole:
Shank Tip is 2" Above Bottom of Side Plates
39256A
39256C
39256B
39256D
Section 3: Adjustments
Shank Adjustments
DANGER
!
To avoid serious injury or death:
Make adjustments to the implement after it has been properly
attached to a tractor and secured with solid non-concrete
supports in the up position. Never work around or under
equipment supported by hydraulics. Hydraulics can drop
equipment instantly if controls are actuated or if hydraulic
lines burst even when power to hydraulics is shut off.
WARNING
!
To avoid serious injury or death:
Always keep your body extremities out from under the shanks
and cutting blades while removing, installing, and adjusting
them. It is possible for the cutting blades and/or shanks to fall
causing injury to your body.
Refer to Figure 3-1:
Shank settings are based on the vertical distance
measured from bottom edge of side plates to bottom of
shank tips. Adjust each shank height as follows:
1. Locate tractor and scraper on a flat level surface.
2. Lower scraper down until the side panels and rear
blades are resting on four 6” high support blocks.
a. Locate two of the support blocks close to the front
of the scraper under both side panels.
b. Locate the other two support blocks under the
grader blades and close to the side panels.
3. Place tractor gear selector in park or set park brake,
turn off engine, and remove switch key before
dismounting tractor.
4. Remove hairpin cotter (#3) and bent pin(#2).
5. Adjust shank (#1) up or down to the desired shank
hole and replace bent pin (#2). Secure bent pin with
hairpin cotter (#3).