Section 1: Options & Accessory Set-up
SPL0548 & SPL0560 Snow Pusher 303-454M
11/9/20
12
Hook-up With BX Quick Hitch
DANGER
!
To avoid serious injury or death: A crushing hazard exists
while hooking-up and unhooking the implement. Do not allow
anyone to stand between impelement and power machine
while approaching or backing away from the implement. Do
not operate lift and/or tilt controls while someone is near the
power machine and/or implement.
WARNING
!
To avoid serious injury or death: Make sure the Snow Pusher
is properly attached to loader hitch plate to keep it from
coming loose and falling. The Snow Pusher’s center hitch pin
must be cradled in the quick hitch j-hook and clevises must be
pinned to the quick hitch with hitch pins. Hitch pins must be
secured with retaining pins.
Follow instructions below if hooking Snow Pusher to
“Kubota Original Quick Hitch” Option No. BX6315.
Refer to Figure 1-6:
1. Check for and remove any debris in the hitch point
areas before hooking up the Snow Pusher.
2. Remove retaining pins (#3A) and hitch pins (#3B).
3. Rotate top of quick hitch forward and lower loader
arms until j-hook (#5) is positioned at a height to fit
under center hitch pin (#2).
4. Slowly drive tractor forward until j-hook (#5) is
positioned under center hitch pin (#2).
5. Slowly raise loader arms and rotate top of quick hitch
back until center hitch pin (#2) is fully seated in
j-hook (#5) and holes in bushings (#4) are in-line with
clevis pin holes (#1).
6. Shut tractor down properly. Refer to
on page 21 without lowering
attachment to ground.
7.
Insert hitch pins (#3B) in clevises (#1) and lower
quick hitch bushings (#4).
8. Secure hitch pins (#3B) with wire retaining
pins (#3A) as shown in Detail A.
Hook-up With Kubota’s Original Quick Hitch
Figure 1-6
Detail A
3B
3A
39717
Kubota’s Original Quick
Hitch Option No. BX6315
See Detail A
