LANCOM L- 54ag Wireless – LANCOM L- 54g Wireless – LANCOM IAP- 54 Wireless
Chapter 2: Installation
18
EN
LANCOM IAP- 54 Wireless
With the LANCOM IAP-54 Wireless the access point’s connectors are located
on the base of the device:
Voltage connector for an external power supply as with the LANCOM 54
Wireless, protected by an IP50 sealing cap.
10/100Base-Tx for connection to the LAN. Supported are 10-Mbit or 100-
Mbit connections. The data transfer speed is recognized automatically
(autosensing).
The LANCOM IAP-54 Wireless LAN connector supports the Power-over-
Ethernet standard (PoE). Further information about PoE is available in the
info box ’Power-over-Ethernet – elegant power supply through the LAN
wiring’
→
page 17.
By activated DSLoL option, the LAN connector can also be used for con-
necting the LANCOM 54 Wireless base station to a broadband modem.
Connection for the serial configuration cable and access to the reset but-
ton, protected by an IP50 sealing cap.
The function of the reset button
The reset button has two different functions depending on how long it is
pressed:
Restarting the device
(soft reset) – push the button for less than five
seconds. The device will restart.
Resetting the configuration
(hard reset) – push the button for more
than five seconds. All the device’s LEDs will light up green and stay on. As
soon as the reset switch is released, the device will restart with factory set-
tings.
