LANCOM 1811n Wireless – LANCOM 1821n Wireless
Chapter 2: Installation
28
EN
Power
This LED provides information on the device's operating state.
The power LED blinks alternately in red/green until a configuration
password has been set. Without a configuration password, the confi-
guration data in the LANCOM is unprotected. Normally you would set
a configuration password during the basic configuration (instructions
in the following chapter). Information about setting a configuration
password at a later time is available in the section 'The Security
Wizard'.
Off
Device switched off
Green
blinking
Self-test after power-up
Green
On (perma-
nently)
Device operational
Red/green
Blinking alterna-
tely
Device insecure: Configuration password not set
Orange/green
In the housing
cover; blinking
alternately with
the online LED
At least one WLAN module is in managed mode and
has not found a WLAN Controller yet. The correspon-
ding WLAN module(s) is/are switched off until a WLAN
Controller is found to supply a configuration, or until
being switched manually into another operating mode.
Orange /red
In the housing
cover; blinking
alternately with
the online LED
At least one WLAN module is in managed mode and
has found a WLAN Controller. However, the WLAN
Controller cannot assign a configuration because the
firmware and/or the device's loader version is not com-
patible with the WLAN Controller.
Red
blinking
Time or charge limit on online connections has been
reached