LANCO
Dr. Lange GmbH & Co. KG
Sure Wisch 6
D-30625 Hannover
Telefon:
Telefax:
E-Mail:
Internet:
+49 (0) 511 9 56 87-0
+49 (0) 511 9 56 87-40
[email protected]
www.lanco.eu
Page 5/5
Manual – ARZ 10, ARZ 204, ARZ 20 – ARZ 60
Erstellt: cschneider
Freigabe: Abé
Version 02
Datum: 20.02.2012
Datum: 20.02.2012
5. Care and Repair Instructions
5.1 General Information
Never pack the tent when it is humid or dirty!
5.2 Cleaning
Only take common gentle cleaning soap.
a) Cleaning all textile parts with tepid, gentle soap-water and use a soft sponge. Always rinse with
clear water completely and let it dry in the air. Please read and act according to cleaning advises
for the fabric when you cannot remove dirt this way.
b) Clean dirty in- and deflation valves and relief valves the same way as above. In case that a valve
is not airtight anymore, please follow step 5.4.
5.3 Repairing of Holes and Fissures
Repairing of holes and fissures at the tent frame, groundsheet or roof can be done with the included
repair set according to its instructions.
5.4 Valve Check
Isn’t a valve airtight anymore, may be dirt under the gasket, which can removed as described:
a) Exhaust all air
b) Fill valve with warm soap-water
c) Press valve tappet: in- and deflation valve from the front, the relief valve must be pressed from
the back through the tube right in the middle.
d) The soap-water should flow into the tube.
e) Fill tube until the valve opens definitely. Check in- and deflation valve if they are tight.
f) If the valve still not working properly, it probably needs to be change.
II. Figures
Fig. 1: Ready to use air-pressure-kit with
bottles (for ARZ 30 / 40).
Fig. 2 The pressure itself isn't enough. Help the tent to
build-up as it is shown here. As soon as the first tube has
reached it final position, walk into the tent and push up the
rest of the arcs (tubes).
