VersaPour Manual
www.lancerbeverage.com
Page 6 of 13
Hoshizaki Lancer reserve the right to change specifications without notice.
Images are for illustration purposes only as product may vary.
No 066 30 October 2017
3.4. Adjust Water to Syrup Ratio
•
Hold LANCER ratio cup under the syrup separator and
activate valve. Check ratio.
•
To obtain desired ratio, use screwdriver to adjust syrup
flow control, (See previous page).
•
Remove syrup separator.
•
Install diffuser and nozzle.
•
Slide down I.D. panel.
3.5. Portion Control Programming
NOTE: The Portion Control Keypad for the VersaPour valve
operates at the touch of a finger and has 5 actuators
(selections): small, medium, large, extra large, and pour/cancel.
The Portion Control Keypad has three (3) automated features: a
five (5) second timer for setting the flow rate, a no top off pour
feature, and a top off pour feature.
Portioned Drink Dispense
•
Fill any cup with the appropriate amount of ice and place
underneath the nozzle.
•
Touch the appropriate portion size button. The valve will pour the
appropriate amount determined by the selection in the previous step.
Flow Rate Setting
•
Place a ratio cup underneath the nozzle.
•
Touch the Small and Large size buttons at the same time.
•
The valve will pour for five (5) seconds.
•
4. Use the amount poured to adjust flow rate as needed, (See previous
page).
No Top Off Programming
•
Place a cup underneath the nozzle.
•
Slide the ID Panel up on the Valve Cover to gain access to Valve LED light located on the back
of the ID Panel
NOTE: When programming slide the ID panel up, removal is not required.
This will enable the blinking LED to be viewed, reflecting on the top of the
valve cover.
•
To enter programming mode, touch the small and extra large sizes at the
same time.
•
To set the portions, touch the corresponding portion size button until the
desired liquid level is obtained.
NOTE: There is a timeout feature that will exit programming mode after
25.5 seconds of continuous pouring or 25.5 seconds of inactivity. If
timeout occurs, all data will be retained; however you must re-enter
programming mode to set any remaining sizes.
•
Press any of the different size buttons to save the portion data.
•
To exit programming mode, touch the pour/cancel button.
