Lance Design ADX-140, Инструкция по установке и эксплуатации

Страница: 13 / 22

13
Config Item 05 – Channel 1 Input (Mic or Line)
Config Item 06 – Channel 2 Input (Mic or Line)
Config Item 07 – Channel 3 Input (Mic or Line)
Config Item 08 – Channel 4 Input (Mic or Line)
These select either mic or line input mode for the input channel. The nominal 0VU
level is +4dBm. Output level at the truck is still adjustable on the ADX-2400. Line
input mode is indicated by a yellow LED adjacent to the XLR input connector.
Config Item 09 – Mic 1 Phantom (On / Off)
Config Item 10 – Mic 2 Phantom (On / Off)
Config Item 11 – Mic 3 Phantom (On / Off)
Config Item 12 – Mic 4 Phantom (On / Off)
Turn on phantom power for Mics 1-4. Indicated by a green LED adjacent to the
XLR. Phantom power is automatically turned off if line in mode is selected.
Config Item 13 – IFB 1 Mode
Controls the signal routing for the IFB 1 XLR output. The selections are as follows:
Wet 2 Ch - Configured as 2-ch RTS-format. IFB1 on Ch1, PGM1 on Ch2.
Dry - IFB - Configured as dry ba4 output of IFB 1.
Dry - PGM - Configured as dry ba4 output of PGM 1.
Dry - Mic 1 - Configured as dry ba4 output of Mic 1*
Config Item 14 – IFB 2 Mode
Configures the IFB 2 output. The selections are as follows:
Wet 2 Ch - Configured as 2-ch RTS-format. IFB2 on Ch1, PGM2 on Ch2.
Dry - IFB - Configured as dry ba4 output of IFB 2.
Dry - PGM - Configured as dry ba4 output of PGM 2.
Dry - Mic 2 - Configured as dry ba4 output of Mic 2*
*Note: these configurations use the IFB connectors as direct line-level outputs of
the mic preamps. The purpose of this is to make that signal available as a
redundant output to be fed to the truck via some other backup system.
Config Item 15 – GPI Inputs (Disabled / Enabled)
Enables operation of the three GPI inputs on the remote connector (D9 connector).
GPI 1 enables a talkback function from Mic 1, using the Mic 3 path. GPI 2 enables
a talkback function from Mic 2, using the Mic 4 path. GPI 3 has no function at this
time.