used for the LAN Data Cables going out to the End IP Devices.
Once you have installed and secured your LAN Data Cables inside the IP67 Enclosure via the Wiring Glands:
5.) Connect the Power Supply Unit for the LP-2354 (which IS NOT SUPPLIED with unit and must be
purchased separately) The LP-2354 can be powered with one of the following units:
a.) Connecting a LAN Power
LP-2575
(Single Port ULTRA High Power Midspan PoE Injector) – Connect
a LAN data cable - CAT 5 (or higher) from the RJ45 port labelled
OUT
(bottom left) of the LP-2575 and
the other end of the cable to the bottom right RJ45 port of the LP-2354 PCB. Once connected the
POWER IN
LED (top right LED of the LP-2354 PCB) will illuminate solid green.
b.) Connecting a LAN Power
LP-2304PSU
(AC Mains Power Supply Unit) – Plug the LP-2304PSU into
an AC Outlet or UPS (Uninterruptible Power Supply Unit). Plug the DIN Plug Connector into the
bottom right DIN Connector Plug (round Power Input) of the LP-2354 (far right of LP-2354 PCB) Once
connected the
POWER IN
LED (top right LED of the LP-2354 PCB) will illuminate solid green. .)If
using a LAN Power LP-2304PSU to power the LP-2354 - Attach a LAN data cable – CAT 5 (or higher)
from the bottom far right RJ45 port (PoE Power Input and DATA OUT) of the LP-2354 PCB to
ETHERNET SWITCH or IP Monitoring Device such as a computer. Up to 100Mbs of data will be
transmitting from this cable which is generated from the IP End Devices.
