Lamtec KS1D, Руководство пользователя

Страница: 9 / 58

8
2 General Safety Instructions
2.4 Safety Equipment/Safety Measures
Hazards from electrical equipment
The LT3 Lambda Transmitter and the Lambda Probe LS2 is equipment for use in industrial
electrical power installations. Always switch off the power when working on mains connections
or mains voltage. If shrouding (for electrical safety) has been removed, reattach it before
switching on the power supply again. Damage to health or equipment may result from improp-
er use or improper handling.
NOTICE
To avoid damage, always observe the respective security notices.
Preventive measures for improving operating safety
If the LT3 is used in conjunction with control and monitoring technology, the operator must en-
sure that any breakdown or failure of the LT3 device does not cause inadmissible damage or
dangerous operating states. To avoid faults which could cause direct or indirect personal or
material damage, the operator must ensure that:
•
the responsible maintenance personnel can be reached at any time and as quickly as pos-
sible
• the maintenance personnel are trained to correctly respond to faults with the LT3 Lambda
Transmitter and the associated malfunctions
• in the case of doubt, the faulty equipment can be switched off immediately
• A switch-off does not lead to direct follow-up problems.
Avoiding consequential damages
To avoid consequential damages in the event of failure, which could cause direct or indirect
personal or material damage, the owner must ensure that qualified personnel can assess the
faults and initiate appropriate measures to tackle them.
Protect against gas leakage from the gas-bearing channel
The Lambda Probe LS2 is fitted directly to the gas-bearing channel via the probe installation
fitting (PIF). If the Lambda Probe LS2 or the installation fitting (PIF) are removed there is a
chance that hot and/or noxious gases, which could be hazardous to health, could egress
through the open orifice in the flue - this is particularly like where the gases in the flue are at
positive pressure. A risk assessment should be carried out and precautions taken to eliminate
any hazardous situation occurring. For prevention, suitable protective measures must be tak-
en in advance.
WARNING!
Discharge of hot, corrosive gases !
In the event of high pressure and temperatures higher than 200 °C (392 °F) in the gas duct,
gas escapes when the LS2 Lambda Probe or the probe installation fitting (PIF) is removed.
 Switch OFF the application before opening.
 Wear protective clothing and a protective mask.
 Affix appropriate warnings near by.
 Close aperture immediately after finishing work.
Decommissioning/recommissioning
The Lambda Transmitter LT3 Lambda Probe LS2 are a high-quality,
electronic measuring system. It therefore requires careful handling in all situations - decom-
missioning, transport, and storage.