Turn off aircraft:short press,then
long press over
3
seconds
Turn off RC
Forward
Left
Right
Forward/Backward
Backward
09:5 9
WLAN
Drone
- xxxxxx
CHOOSE A NETWORK...
18
19
DF805B
Operation Manual
DF805B
Operation Manual
6. Return To Home
In GPS positioning mode, you can press the
“
One Key Return
”
button to return the aircraft. Do not control any functions during
the process of return or ascent. When the aircraft is landing, you can toggle the joystick as to control it to land on your desired
location. When the aircraft is returning to home point, long press the
“
Return
”
button to exit auto return mode.
Note: As for the return to home point as precise as possible, please ensure the GPS positioning function has
been turned on to record the aircraft’s position before its takeoff and choose an area with no obstacles.
With the GPS positioning mode turned on, it will automatically enter auto return to home mode if the remote
controller loses control.
Once the auto return to home mode is enabled, if the aircraft flies below 30 meters of altitude, the aircraft
will automatically ascend to 30 meters before returning to home point. However, if the aircraft flies over 30
meters of altitude, the aircraft will return to home point at the current altitude. Please do not control other
functions during the process of return. Please ensure there are no obstacles in way of return in case of any
potential accidents.
When the aircraft lands, please turn off the aircraft and the remote control power after the propeller stops rotating(long press power
button over 2seconds)
Caution:Please stay away from aircraft until propellers stop rotating completely.
7. Remove the battery and store it separately
(1) When finishing flight,please remove the batteries from the aircraft and remote controller and store them separately.
(2) Keep batteries out ofthe reach of children. Keep the battery dry. DO NOT leave the battery near heat sources such as a furnace
or heater. The ideal storage temperature is 22
℃
-28
℃
.
(3) If a battery is found to be damaged,please discharge the battery and dispose them properly according to the local regulations
and laws.
8. Pair aircraft and RC
Factory default settings is that remote controller and aircraft already paired. If remote controller has been replaced or other reasons
that will cause the aircraft and the remote controller not paired, please complete the pair as follows.
(1) Turn on aircraft and RC;
(2) Open mobile phone,enter setting-WLAN,check the wifi list,users can see two wifi named as below:Drone-xxxxxx,and Controller-
xxxxxx;
(3) Choose Drone-xxxxxx,then connect as left picture shown:
(4) Enter APP interface,then click .... as right picture shown:
(5) Choose pair as pictures shown:
(6) Pop up the scan for device,click scan for device,scan Controller-
xxxxxx,and connect as pictures shownExit APP,enter setting -
WLAN on user phone,choose Controller-xxxxxx,if can connect
successfully,which means RC and aircraft paired,users can use
the RC to control aircraft
IX. Flying by APP
1. Power on
(1) Put the aircraft on a fat surface
(2) Turn on aircraft Long-Press power button 2s.
After power on the aircraft,ensure that aircraft is positioned on flat ground more than 30seconds to make the aircraft complete self-
inspection,when indicator convert flashing blue to flashing green or always green,which means
paired with RC complete
2. Connect with the APP
(1) In the mobile phone with APP installed,click WLAN
setting,choose”Drone-xxxxxx”,and connected
Содержание DF805B
Страница 15: ......
