User guide rev 7 .doc - Page 5
LAMPOCICLO USER GUIDE
www.lampociclo.com [email protected]
Unpacking, assembly and first ride
1.
Unpacking from shipping box
1.1.
To extract the bike from box we suggest you to put the box in a vertical position, hold the bike in
“wheeling position”, pull it towards you. We recommend storing the box after assembly.
2.
Preparing for first use
2.1.
Lift the handlebar, set it to 90° with front wheel and tighten it with an allen key. The brake levers
will also need to be tightened with an allen key.
2.2.
Screw in pedals with a pedal key
3.
Electric system: the battery is supplied half charged and will reach maximum performance after 3
charge/discharge “brake in” cycles. A full charge cycle will take up to 6 hours. However, the first charge
should take much less. To charge the battery follow the
instructions below:
3.1.
Lift and offset the “gas cup” (A) exposing the bike plug.
3.2.
Connect the charger to the main electric plug (B)
3.3.
Connect the recharge plug (C) to the bike plug (D)
3.4.
Both charger lights will become red (E) and the cooling fan
may start. When the charge is complete one of the lights
will turn green. Please note it is useful to leave the
charger connected for an extra 20 minutes, after light
turns green, in order to allow internal cells balancing.
3.5.
When ready insert the “cut off key” on the bike (F)
3.6.
If you wish to use the bike without pedal assistance, simply remove the “cut off key” (F)
4.
Parking: Remove the “cut off key” (F) to avoid theft or electric charge dispersion.
